|
Truss Display Backdrop SystemTruss System or Mobile Frame is main reasons for large scare stage backdrop / wall display because there’s no plastic parts to break and easy screw type fasteners that you can over tighten and strip. This truss system looked professional and very durable.
Set up and tear down can easily be done by one or 2 person within 15 minutes (Depend How big the system require to use in your event). One tool you will need though is a hammer and a Leatcher since some of the screw point, connector & pins fit a little tight you will need to tap them in gently. Setting it up may start on the ground and then lift it up. Tearing the truss down is easy too, just do everything in reverse. *TRUSS SYSTEM IS CUSTOMIZABLE ACCORDING TO PREFERRED SIZES* |
Standard Wall Backdrop Truss - MX-TS 3X3
Product Code MX-TS 3X3
Graphic Side: 1 or 2
Sizes: W 8.84 feet x H 8.84 Feet
Component:
TS115C = 6 Units,
TS45C = 4 Units
Cube Connector TSC = 6 Units
*No Bag Included
Material: Full Metal
Application: For Booth 3x3 Meter (Indoor or Outdoor)
*Printing Not Included
Sizes: W 8.84 feet x H 8.84 Feet
Component:
TS115C = 6 Units,
TS45C = 4 Units
Cube Connector TSC = 6 Units
*No Bag Included
Material: Full Metal
Application: For Booth 3x3 Meter (Indoor or Outdoor)
*Printing Not Included
Basic L Wall Truss - Product Code MX-TSLW
Graphic Side: 1 or 2
Sizes: W 12.10 feet x H 8.10 Feet
Component:
TS115C = 10 Units
Cube Connector TSC = 6 Units
*No Bag Included
Sizes: W 12.10 feet x H 8.10 Feet
Component:
TS115C = 10 Units
Cube Connector TSC = 6 Units
*No Bag Included
